Hot and Cold Weather Procedures for Repairing Windscreen Glass
Summer is peak season for repairing windscreen glass. Longer journeys, loose chippings and thermal stress all push chip and crack volumes up, and mobile technicians find themselves working flat out through July and August. The problem is that the same heat driving demand also works against the repair itself. Resin behaves very differently at 30 degrees on a sunlit driveway than it does in a shaded workshop in April, and technicians who do not adjust their process will see fill quality suffer.
Why heat changes resin behaviour
Windscreen repair resin is formulated to flow into a break at a controlled rate and cure under UV light. Temperature affects both stages. As glass and resin heat up, viscosity drops, so a resin that fills cleanly in mild conditions can become too thin, flowing out of the break as quickly as it flows in and leaving voids behind.
The bigger issue is premature curing. On a bright summer day, ambient UV is strong enough to begin curing exposed resin before the fill is complete. If resin starts to gel while you are still injecting, it can seal the surface of the break and trap air inside, leaving the repair cloudy and structurally compromised. What looks like a resin fault is often simply sunlight doing its job too early.
Hot glass compounds the problem. A windscreen left in direct sun can easily exceed 50 degrees at the surface. Injecting resin into glass that hot accelerates the chemical reaction, shortens your working time and increases the risk of the crack spreading as the glass flexes with temperature change.
Cooling the glass before you start
Never begin a repair on sun-heated glass. Move the vehicle into shade where possible, or create shade with a canopy or windscreen cover. Allow the glass to cool gradually. Avoid the temptation to speed things up with cold water or air conditioning blasted at the screen, as rapid temperature change is one of the most common causes of cracks running mid-repair. A gradual cool-down to a stable, touchable temperature protects both the glass and your working time.
Managing UV exposure during the fill
Once the injector is set, shield the repair area from direct sunlight for the entire fill and vacuum cycle. A simple UV shield or even careful positioning of your body and equipment can make the difference between a complete fill and a trapped bubble. Only expose the resin to UV once you are satisfied the break is fully filled, then cure deliberately with your lamp rather than relying on ambient light, which cures unevenly.
Adjusting resin choice for summer
Many technicians run the same resin all year, but a viscosity that suits winter conditions is often too thin in summer heat. Moving to a slightly higher viscosity resin during the warmer months restores control over flow and extends working time. It is also worth reviewing where resin lives between jobs. The inside of a van parked in the sun can reach temperatures that degrade resin well before its stated shelf life, so store bottles in an insulated container away from light and check stock regularly through the season.
Small adjustments, better repairs
None of this requires new equipment or a different process, only awareness of what heat is doing at each stage. Cool the glass, shield the break, slow the cure and match your resin to the season. Technicians who make these adjustments consistently deliver clear, structurally sound repairs through the hottest weeks of the year, and avoid the callbacks that come from rushed summer fills.
Stocking up on higher viscosity resins, UV shields and proper resin storage before the season peaks means you are ready when demand arrives.





Comments